It makes the soil under your foundation the lowest-pressure spot in the equation. A pipe cored through the slab connects to a quiet inline fan that runs continuously, pulling soil gas out from under the house and releasing it above the roof, where it disperses.
More detail
The full name is active soil depressurization, and the install has four parts. A suction cavity: a hole cored through the slab with a bucket or two of material excavated beneath it, so the fan's pull spreads laterally under the floor. The pipe run: PVC routed up through a closet, garage, or exterior wall to a discharge above the eave, placed away from windows and air intakes. The fan: mounted in the attic, garage, or outside, never below the living space, so any leak on the pressure side stays out of the house. And sealing: the floor-wall joint, accessible cracks, and the sump lid closed so the fan draws on soil rather than on conditioned basement air. A manometer on the pipe shows the vacuum at a glance. EPA puts active sub-slab suction at a 50 to 99 percent reduction, and the post-install retest shows where your house lands in that range. See the mitigation systems page and verification testing.