Passive vs Active Radon Systems
Metro Denver is full of houses with a radon pipe and no fan, because many Front Range jurisdictions require radon-resistant features in new construction and builders rough the vent in during framing. The question those homeowners face is whether the passive stack is enough, and the honest answer comes from a test, not from the pipe's existence. This comparison lays out what each version does, what each costs to own, and when the upgrade earns its keep.
Passive vs Active Radon Systems
Metro Denver is full of houses with a radon pipe and no fan, because many Front Range jurisdictions require radon-resistant features in new construction and builders rough the vent in during framing. The question those homeowners face is whether the passive stack is enough, and the honest answer comes from a test, not from the pipe's existence. This comparison lays out what each version does, what each costs to own, and when the upgrade earns its keep.
| Feature | Passive system (pipe, no fan) The builder's rough-in, moved by buoyancy alone | Active system (fan-driven) Continuous mechanical suction under the slab |
|---|---|---|
| How it moves gas | Warm-pipe thermal buoyancy: air in the stack rises because it is warmer than outdoors | An inline fan holds constant vacuum under the slab or membrane, around the clock |
| Typical effectiveness | Partial. Helps most in cold weather, fades in shoulder seasons, and often leaves Front Range homes above 4 pCi/L | Reductions of 80 to 99 percent are routine; most homes land under 2 pCi/L |
| Where you find it | Newer subdivisions where a local code or the builder added radon-resistant features, from Broomfield to Castle Rock | Any home after mitigation, and new builds whose owners activated the rough-in |
| Operating cost | Zero | A continuously running fan, roughly 20 to 90 watts, a few dollars a month at Xcel rates |
| Noise | Silent | A faint hum when placed and coupled correctly; see the fan noise FAQ |
| Upgrade path | Add a fan at the attic junction, confirm the roof exit, add a gauge: $650 to $1,100 | Already there; fans replace in an hour when they age out |
| How you know it works | You do not, without a test; there is no gauge on a passive stack | A manometer shows suction at a glance, and the verification test proves the number |
| In a home sale | A rough-in is a selling point only alongside a recent passing test | A documented system with license number and retest closes the radon question |
Our recommendation
Test first, always: a passive house that reads under 2 pCi/L in winter needs nothing, and nobody should buy a fan to fix a number they never measured. When a passive home tests at 4 or above, or sits in the 2-to-4 band with bedrooms on the lowest level, activation is the obvious move, since the expensive infrastructure already exists and the conversion is the cheapest mitigation work sold. When a passive home tests borderline in summer, retest across the heating season before deciding. And when buying new construction, treat the pipe as a head start rather than an answer: run the same test every house deserves.
Ready to get started?
About half of Colorado homes test over the EPA action level, and every metro county is EPA Zone 1. Mon-Sat 8am-7pm.